Apdeck 700 - Concealed Fix Deck

Rib Height: 42mm
Apdeck 700 Roofing

 

 

 

 
 

Maximum Span Tables - (Approx Only)
BMT
 
TCT
 
MASS
KG/M2

COVER
(MM)

ROOF
INTERNAL
ROOF
END
ROOF
PITCH
0.42 0.47 4.74 700 1800 1500 2 deg
0.48 0.53 5.37 700 2400 1800 1 deg

RECOMMENDED FIXING METHOD
When fastening into Steel Purlins, use 10 Gauge x 16mm Hex Head Screws, 4 per clip.
When fastening into timber battens, use 12 Gauge x 25mm Hex Head Type 17 screws, 4 per clip (softwood), and use 12 Gauge x 40mm Hex Head Type 17 screws, 4 per clip (hardwood). Allow 1.3 clips per square metre. This is based on 1200mm batten centres

MATERIALS
G550 base material (550Mpa minimum yield stress) with ZINCALUME® (AZ150) coating, in accordance with AS1397. COLORBOND® is available in a number of colours and thicknesses. Please inquire with our sales department for availabiltiy.


ADVERSE CONDITIONS
If the distance is within 1km of salt marine or industrial or corrosive environments, please contact our office for advice.

WARRANTIES
Our products are supported by Bluescope Steel Limited and a full warranty is available.

TESTING
Apdeck 685 has been fully tested by Vipac Engineers and Scientists Limited and in accordance with AS1170.2 and AS1562.1. Detailed test results are available upon request.

LENGTHS
Apdeck 685 is available in custom cut lengths to your requirements. Please check with our office as to what is the maximum length we can transport as restrictions apply.

HANDLING
Care should be taken at all times when handling Apdeck 685. Packs must be kept dry and stored above ground level. If sheets do become wet, separate and wipe sheets and place in an area for drying.

COMPATIBILITY
Lead flashings and copper alloy materials are not recommended and should not be used with or in run-off situations with ZINCALUME® sheeting. Lead head nails are also not to be used

CUTTING
Sheets are available cut to length, however, sheets may be cut using a power saw with a metal cutting blade. When cutting COLORBOND® sheeting, sheets must be laid with the coloured surface facing the ground. Ensure any hot particles or debris does not come into contact with the COLORBOND® sheeting.

CLEAN UP
To prevent premature corrosion, after each days work is completed, the sheeting area must be thoroughly cleaned of all debris, including nails, rivets, rags and especially filings from cutting or drilling.

WALKING
Clean soft soled shoes should be worn when walking on sheets.

DELIVERY
Normally delivery can be made to site within 1 to 2 days. To prevent any damage whilst unloading, we require suitable arrangements be made. If crane unloading, ensure load is spread evenly. If no crane is available, people must be on hand to assist in unloading.